Signaline SLP-001 LocatorPlus Dual Zone Monitor Module SLP-001 Vimpex

Description

Signaline LocatorPlus Dual Zone Monitor Module The Signaline SLP-001 LocatorPlus is a combined distance locator and monitor module compatible with all Signaline FT and FT-R linear heat detection cables. UL approved the LocatorPlus gives users instance alarm point location along the Signaline FT linear heat detection cable. However, unlike previous locator devices the LocatorPlus can then remotely report this location via the MODBUS output.  Furthermore, the LocatorPlus can offer location along 2 different zones of Signaline FT cable, each upto 3000m long. The LocatorPlus also acts as a monitor module for the linear heat detection. It will report both fire and fault on either zone. These alarms are also indicated via an internal buzzer and LEDs on the LocatorPlus. The LocatorPlus is compatible with any conventional fire detection panel or can operate on an addressable interface. The LocatorPlus can also be used as the activation device on gas releasing panels. The LocatorPlus has two operating modes. Independent mode will report an alarm on either zone of cable independently. However, if set to interlocking the alarm relays are not triggered until both zones are in alarm. Thereby removing any risk of false alarms. Signaline SLP-001 LocatorPlus Specification Model : Signaline LocatorPlus (SLP-001) Dimensions : 180 x 120 x 60.5mm HxWxD IP Rating : IP65 Finish : Light Grey with clear lid Display : 2 line, 16 character backlit display showing zone status Approvals : UL 864 10th ed. Operating voltage : 12-36Vdc Operating current : <12mA <4mA Alarm current : <40mA <15mA Operating temp. range : -20°C – +50°C (-4°F – +122°F) Terminal blocks : Spacing 5mm Rising Clamp Rating : 16A Wire size : 0.08mm2 (28AWG) to 4mm2 (11AWG) Supervised circuits : Power, Input Zone 1 & Input Zone 2 Inputs : Up to two zones of Signaline FT or FT-R Linear Heat Detection Zone length : 1-3000m (10,000ft) End of Line resistor : 1kohm (included) Short circuit current : 0.5mA Max voltage : 5V Ground fault impedance : 0ohms Communications : Two wire RS-485 Modbus RTU (field wiring limited to same room to comply with UL listing) Sounder : 2.4kHz 92dBa @ 10cm Buzzer Alarm : 2x Form C volt-free relay contacts (resistive, com-mon) Max V : 30Vac or 42.4Vdc Max Current : 2A Max Switching Power 60W, 62.5VA Fault : 2x Optoisolated phototransistor output (resistive, common) Max V : 35Vdc Max Current : 80mA Max Power Dissipation 150mW